0℃~120℃ Capillary Steel Thermostat Cooling Radiator Fan Control Switch
Specifitions:
Voltage:12V
Material:Steel and Plastic
Temperature range: 0℃~120℃
Accuracy:4±2℃
Temperature bar length:104mm
Temperature sensing rod diameter:5mm
Capillary length:1000mm
Feature:
Allows you set the temperature you wish the cooling fan to operate between 0℃~120℃
Suitable for use with any after-market Cooling Fan with 12V
The Fan will kick in at the selected temperature and then switch of when the engine temperature goes back down
To fit in the hose simply remove the top radiator and fully insert the probe, then re-fit hose and tighten over the capillary wire being extra careful not to damage the probe inside. Silicone sealant can be used to help seal if required.
Wiring Instructions
C Terminal = 12v Feed
No2 Terminal= Power out to the fan
(the switch is earthed through the fan)
No1 Terminal= Leave blank, this is not required for this application
You can also wire a relay in if you wish, but this is not a requirement.
Package Included:
1x Switch
